How To Build a Shower Opening

Shower Doors

Tip #1: Where to Install Shower Head

Even in a large shower, always install faucets and shower heads so that they spray towards a shower wall, not towards the shower door.

Tip #2: Design for a Standard Size Shower Door

A custom-cut glass shower door will be required for openings that do not have plumb rises for swinging doors.

Tip #3: Use 90 Degree Angles for Door Hinges

Shower doors, like all other doors, must be installed at a 90 Degree angle in order for the door to open freely.

Tip #4: Installing Shower Transoms

Framed shower doors over 78" tall will require installing a transom. Transoms are also used to create steam showers and can be adjustable to allow ventilation. Frameless doors that are 3/8" thick and over 84" tall or 1/2" thick and over 103" tall require transoms.

Tip #5: Installing Shower Soffits

For other types of tall showers, soffits cans be installed instead of a transom. Shower soffits must plumb down precisely to the footprint of the lower curbs.

Tip #6: Installing Wood Studs

The wall on which you would like to mount a hinged shower door should have wood studs or "blocking" behind it. If metal studs were used in the original construction of the wall, wood studs should be added at location of hinges. If we are unable to locate wood at time of installation we have a variety of anchors that will work. However, this is not the best method and some door sag may occur over time, requiring adjustment.

Tip #7: How to Properly Install Shower Seats

Seats and curbs inside the shower should not be flat. Instead, they should be pitched slightly into the shower in order to drain properly.

Tip #8: How to Build Shower Curbs

A shower curb must be designed and pitched properly in order to keep water inside the shower. A level curb does not shed water properly and will eventually lead to a standing water and mildew. An outward sloped curb creates problems, because it directs water under the door and onto the bathroom floor.
Properly pitched curbs will always be sloped into the shower (ideally 3/8" from outside of curb to inside of curb.) However, a curb that is over-pitched will wear down the door gasket and may eventually damage the shower door

Tip #9: Designing Neo-Angle Showers

For neo-angle showers, use 135 degree angles.

Tip #10: Do Not Use Small Glass Panels

Glass panels must be manufactured with at least 4" in width.

Tip #11: Do Not Use Raised Features Near Shower Opening

Designing a shower with raised tile near the glass door may result in a damaged door or hinder the door from opening properly.

Tip #12: Using Glass Tiles

Glass tiles are fragile! While we use the best tools and take every precaution, drilling necessary during the installation process may result in cracked tile at your risk. Try to avoid placing glass tiles in the areas where shower door hinges will be attached.

Tip #13: Build Flush Openings

Overhangs near door closings create gaps, resulting in unsightly fillers or the need to cut a notch in your granite, marble or other surface. Please mount the top of seats and knee walls flush with the sides.
Call us today at 404.351.4141

or visit our Atlanta Showroom to meet a glass expert and review your project.